138.68.75.163Ĭonnecting to ()|138.68.75.163|:80. Linux can control a laptops fan speed through the use of software programs such as lm-sensors or fancontrol. When downloading the packages i get a lot of these messages: Btw what's the difference between m and y?Īnd how do i add fancontrol to the filesystem? mentioning that 'IIS worked fine and start failing after Fall Creators update' if that is the case for your machine would make this question easier to use by future visitors). explaining what your setup and what you believe would help other users to identify their have same problem (i.e. I added the CONFIG_SENSORS_NCT6775=m to the linux_x86_64.conf file. Please consider to improve the question - i.e. I cloned the git, but building this is relative new to me. I ran sudo sensors-detect then sudo pwmconfig (the process of pwmconfig is shown down below) and now wanted to modify the fancotrol file (also copy pasted down below) so that the fans only work at high temperatures, but unfortunatly the does not have any pairs of fans and pwms anywhere, so that it is useless. If i copy it to that folder or any of the sub folders it still nags that it can't find it. ESPHome is a system to control your ESP8266/ESP32 by simple yet powerful configuration files and control them remotely through Home Automation systems. When i enter modprobe nct6775 on the prompt it says modprobe: FATAL: Module nct6775 not found in directory /lib/modules/5.10.76 (~/.cache/kernel-overlays/base/lib/modules/5.10.76/kernel/drivers/hwmon/nct6775.ko) 1 I would like help to know hot to configure fancontrol, I already check: For now, I only found how to set one fan to one temp sensor. I found /storage/.cache/kernel-overlays so i made the same directory structure and placed the module in there, but that gave me also zero result. If that's the equivalent for linux /lib/modules/5.13.0-25-generic/kernel/drivers/hwmonĬan i copy the nct6775.ko file to that directory and if so how, because it is read only? It should be in: /usr/lib/kernel-overlays/base/lib/modules/5.10.76/kernel/drivers/hwmon i guess So i have no clue of the config file did nothing, or it is because of a missing module? Not even a mentioning in the logs if it could start/find it or not.Īlso when i search for the module i can't seem to find it. Save the configuration file Finally, run sensors command in Linux to see CPU. I made a file called nfig with modulename in it and put it in that folder, but after a reboot nothing. Linux Read CPU Temperature Sensor Chip Data Including Voltage and Fan Speed. I found this ~/.config/modules-load.d folder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |